Your local Toorak electrician, on-site today, priced before we start.

A switchboard upgrade in Toorak is usually about capacity as much as safety. We replace ceramic fuses and older rewireable boards with a modern enclosure, individual RCBOs on every circuit, correctly rated main switch and surge protection, then label each circuit so the next person who opens the door knows exactly what they're looking at. Where the property is on three-phase supply, we balance the load properly rather than stacking everything on one phase.

For emergency electrician work in Toorak, the calls we take most are total power loss, one dead phase, repeated safety switch tripping and burning smells from a board or outlet. We answer around the clock and carry the common failure parts, so most faults are diagnosed and made safe on the first visit rather than being propped up and rebooked.

If a circuit keeps dropping out and no one has explained why, that's electrical fault finding, not guesswork. We isolate circuit by circuit, test insulation resistance and earth continuity, and identify the actual failure point, most often a water-affected outdoor fitting, a failed appliance or a degraded connection in the board.

Smoke alarm compliance matters in large homes because a single hallway alarm is nowhere near enough. We install interconnected photoelectric alarms so that every unit sounds together, which on a three-level Toorak house is the difference between hearing an alarm and sleeping through it. For rental and investment properties we handle the annual safety checks and supply the documentation.

EV charger installation is now one of our most common Toorak jobs. We assess the existing supply, confirm whether the board can carry a 7kW or 22kW charger, run the dedicated circuit along the cleanest route we can find and commission the unit with load management where needed, so charging never trips the rest of the house.

We also handle partial and full rewiring, new lighting layouts, dimmer and downlight replacements, ceiling fans, garden and facade lighting, and additional power circuits for renovations. Everything is tested on completion and signed off with a Certificate of Electrical Safety.